当前所在位置:首页>>beplay体育备用>>铜门现场施工未完成时要注意几个情况
beplay体育备用
分类导航
推荐新闻
联系我们
beplay电话多少
联系电话:15066683078
联系地址:济南市天桥区历山北路黄台装饰不锈钢市场北区28号
铜门现场施工未完成时要注意几个情况
来源:
//www.doveish.com日期:2022-08-30 发布人:qinfu浏览次数:
山东铜门在安装完毕后,现场施工还没完成,装修还在进行,请注意以下情况:
After the installation of Shandong Tongmen, the on-site construction has not been completed and the decoration is still in progress. Please pay attention to the following conditions:
(1)用指定合适的环保包装袋覆盖好铜门的表面,告知装修所有工人出入门口注意安全保护;
(1) Cover the surface of the copper door with the designated appropriate environmental protection packaging bag, and inform all decoration workers to pay attention to safety protection at the entrance and exit;
(2)避免任何的坚硬物对门碰撞、摩擦导致铜门内或表面层的损坏,或使得后期铜门更容易发生氧化反应。
(2) Avoid the damage of the inner or surface layer of the copper door caused by the collision and friction of any hard object on the door, or make the later copper door more prone to oxidation reaction.
(3)不能有水泥、油漆等其它酸、碱成分的物质靠近或碰触铜板表面,如不慎碰触,必须及时清除以减少对铜板的侵害。可用清水棉布慢慢擦试去掉。
(3) Cement, paint and other substances with acid and alkali components shall not approach or touch the surface of the copper plate. In case of accidental contact, it must be removed in time to reduce the damage to the copper plate. Use clean water and cotton cloth to wipe it off slowly.
此外在使用时,铜门在打开和关闭时要注意力度,需要均匀用力,铜门本身不易损坏,但门上的一些(机械配件)使用过程中会有适当的磨损,或者不灵活,因此使用过程中尽量避免强开强关。不灵活的地方可以用少许的润滑油,但不宜多用,润滑后即用棉布擦干油渍避免吸附灰尘。
In addition, during use, pay attention to the strength when opening and closing the copper door, which requires uniform force. The copper door itself is not easy to be damaged, but some (mechanical accessories) on the door may be properly worn or inflexible during use. Therefore, forced opening and closing shall be avoided as much as possible during use. A small amount of lubricating oil can be used for inflexible places, but it is not recommended to use more. After lubrication, wipe the oil stain with cotton cloth to avoid dust absorption.
清除铜门表面污迹时(如手印),可采用哈气打湿后,用软布擦拭,用硬布很容易划伤表面,污迹太重时可使用中性清洗剂、牙膏或家具专用清洗剂,去污后,立即擦拭干净。铜门的棱角处不要经常磨擦,以免造成棱角处饰面材料褪色破损。
When removing the stains (such as handprints) on the surface of the copper door, it can be wiped with soft cloth after being humidified by air. It is easy to scratch the surface with hard cloth. When the stains are too heavy, neutral detergent, toothpaste or special cleaning agent for furniture can be used. After decontamination, it can be wiped immediately. The edges and corners of the copper door shall not be frequently rubbed to avoid fading and damage of the facing materials at the edges and corners.
铜门现场施工未完成时要注意以上几个情况,有助于铜门质量的完成,以及现场施工的顺利完成,更多事项就来我们网站
//www.doveish.com咨询了解吧。
When the on-site construction of the copper gate is not completed, pay attention to the above conditions, which will help to complete the quality of the copper gate and the smooth completion of the on-site construction. For more information, please visit our website //www.doveish.com Consult and understand.
- 上一篇:庭院铜门刮擦后的处理事项
- 下一篇:铜门内在的结构组成是怎样的?