Although copper door is a relatively expensive product, with the continuous improvement of people's living standards, many people also have higher consumption pursuit. Although the price of copper door is high, it is still accepted by the majority of consumers because it has the advantages of beauty, anti-theft and so on.

现在我们生活中所使用的铜门是越来越多，其实无论是什么样的门，都需要我们在日常使用中进行保养的，这样它们的使用寿命才会更加长久。特别是铜门，铜门大多数情况下都被我们使用在小院里，因为铜门本身就具有非常奢华的感觉，所以它和别墅可以说是非常好的合作。下面小编为大家介绍铜门保养方法及铜门安装注意事项。

Now more and more copper doors are used in our life. In fact, no matter what kind of doors, they need to be maintained in daily use, so that their service life will be longer. In particular, copper doors are mostly used by us in the courtyard. Because the copper door itself has a very luxurious feeling, it can be said to be a very good cooperation with the villa. The following small series will introduce the maintenance methods of copper doors and precautions for copper door installation.

铜门保养方法方法一、加装弹性挡门块。家居的铜门常常要开关，当铜门打开后，往往直接抵撞着墙，时间久了，门上的锁盒和拉手容易在墙面上碰出印痕，损坏墙和铜门，影响美观。

Copper door maintenance method 1. Install elastic door stop. The copper door at home often needs to be opened and closed. When the copper door is opened, it often directly butts against the wall. Over time, the lock box and handle on the door are easy to hit marks on the wall, damaging the wall and copper door and affecting the beauty.

方法二，弄掉铜门表面污迹时（如手印），要用软布擦拭。用硬布很容易划伤表面，污迹太重时可使用中性清洗剂、牙膏或家具专用清洗剂，去污后，立即擦拭干净。铜门的棱角处不要经常磨擦，以免造成棱角处饰面材料褪色破损。

Method 2: when removing the stains on the surface of the copper door (such as fingerprints), wipe it with a soft cloth. It is easy to scratch the surface with a hard cloth. When the stain is too heavy, you can use neutral detergent, toothpaste or special detergent for furniture. Wipe it immediately after decontamination. The edges and corners of the copper door shall not be frequently rubbed to avoid fading and damage of the finishing materials at the edges and corners.

方法三、保护铜门重要的就是要保护门表面的那层油漆。避免跟尖锐、坚硬的东西碰撞。铜门表面的油漆对铜门内部的材质有很好的保护作用，要是表面油漆出现脱落，里面的电解板就会裸露在外面，和空气内的氧气产生反应，而生锈，影响美观。

Method 3. The important thing to protect the copper door is to protect the layer of paint on the door surface. Avoid collision with sharp and hard objects. The paint on the surface of the copper door has a good protective effect on the material inside the copper door. If the surface paint falls off, the electrolytic plate inside will be exposed to the outside and react with the oxygen in the air, resulting in rust and affecting the appearance.

方法四、如果在装修时期已经把铜门安装好了，请勿急着把腹膜纸去掉。因为粉刷的时候掉落在铜门上的水泥和油漆等化学物质，容易起黑点至生锈。而腹膜纸也不能长时间在铜门上，时间长了容易粘在门上，致使门的外表的光漆损坏，所以要在七天之内把腹膜纸撕掉。

Method 4. If the copper door has been installed during the decoration period, do not rush to remove the peritoneal paper. Because the cement, paint and other chemicals falling on the copper door during painting are easy to get black spots and rust. The peritoneal paper can not be on the copper door for a long time. It is easy to stick to the door for a long time, resulting in damage to the light paint on the outside of the door. Therefore, the peritoneal paper should be torn off within seven days.

方法五、日常保养铜门的时候，要拿干毛巾来擦拭。清洁时不要使用会破坏油漆的清洁剂，防止铜门表面的的保护层被损坏。铜门日常开关时，不要太大力，要缓慢地开关，这样能够很好的防止铜门和另外一些东西出现碰撞而撞坏表面的保护层。

Method 5. When maintaining the copper door, wipe it with a dry towel. Do not use cleaning agents that will damage the paint during cleaning to prevent the protective layer on the surface of the copper door from being damaged. When the copper door is opened and closed daily, do not use too much force, but open and close slowly, which can well prevent the copper door from colliding with other things and damaging the surface protective layer.

方法六、门窗上要是出现了油污等污渍要用中性的清洁剂来洗掉。铜门虽然防腐，但遇到大量硫及硫化物时，还是容易产生化学变化。所以，需要提醒您的是，铜门尽量避免受雨雪淋落，防止降水中硫化物腐蚀。

Method 6. If there are oil stains and other stains on doors and windows, wash them off with neutral detergent. Although the copper door is anticorrosive, it is easy to produce chemical changes when encountering a large amount of sulfur and sulfide. Therefore, you should be reminded that the copper door should be protected from rain and snow as far as possible to prevent sulfide corrosion in precipitation.

铜门安装注意事项一、安装方法、测量洞口规格是否相等。如小于铜门的规格，应铲除灰皮。

Precautions for copper door installation I. installation method and measuring whether the specifications of openings are equal. If it is smaller than the specification of the copper door, the ash skin shall be removed.

1、铜门按洞口位置摆平放平，在门框四个安装孔用m12钻头钻孔，用m12母栓固定后再进行调整。

1. The copper door shall be leveled according to the position of the opening, and the four mounting holes of the door frame shall be drilled with M12 drill bit, fixed with M12 female bolt, and then adjusted.

2、调整方法：以铜门门扇外面以基准平面，桧验门框安装后是否与门扇平行。如果门框与门扇不平行，在门框背面靠近螺丝位置加木垫试蛰，直到门扇平行为止。

2. Adjustment method: check whether the door frame is parallel to the door leaf after installation with the reference plane outside the copper door leaf. If the door frame is not parallel to the door leaf, add a wooden pad near the screw on the back of the door frame to test the sting until the door leaf is parallel.

二、填充水泥方法、因为铜门门框是空心的，为了使铜门更加牢固，要在门框空心处填充水泥，在填充水泥前把门关好，请注意在门扇开启面，门框与门扇之间应加塞纸垫。

2、 Cement filling method: because the door frame of the copper door is hollow, in order to make the copper door more firm, fill the hollow part of the door frame with cement, and close the door before filling the cement. Please note that a paper pad should be inserted between the door frame and the door leaf on the opening surface of the door leaf.

1、填充水泥不能过，否则使门框变形，影响门的使用和开启。

1. The filling cement shall not be too, otherwise the door frame will be deformed and the use and opening of the door will be affected.

2、填充水泥24小时后将纸垫取下，轻轻打开门扇，用螺丝刀将框内钻孔部位的水泥刮干净，在把安装孔盖住。

2. After filling cement for 24 hours, remove the paper pad, gently open the door leaf, scrape the cement at the drilling part in the frame with a screwdriver, and cover the installation hole.

3、如果框内不填充水泥，彩响使用功能，后果自负。

3. If the box is not filled with cement, the color sound function will be used at your own risk.

三、使用安装片安装方法、把铜门门扇取下，将门框放进门洞，用水平尺铅垂检査是否摆放平整。若不平整，用木片垫平整、先以铜门的内门一侧作基准边，把门框加强筋上的安装片旋转至与门框垂直，然后将安装片折弯，用水泥钉固定于墙上。

3、 Remove the copper door leaf by using the installation method of installation piece, put the door frame into the door opening, and check whether it is placed smoothly with a level ruler. If it is not flat, use wood chips to make it flat. First, take one side of the inner door of the copper door as the reference edge, rotate the mounting plate on the reinforcing rib of the door frame to be perpendicular to the door frame, then bend the mounting plate and fix it on the wall with cement nails.

1、将内门套上门框并锁好，在确保平整的情况下，相继把内门锁侧安装片面定在墙上。

1. Put the inner door on the door frame and lock it. Under the condition of ensuring flatness, successively fix the side of the inner door lock on the wall.

2、用同样的方法将外门套上门框，固定好安装片。

2. Use the same method to fix the outer door cover to the door frame and the installation piece.

3、检査内门、外门开关是否灵活，若有异常，可塞木片做进一步调整。

3. Check whether the switches of inner and outer doors are flexible. If there is any abnormality, plug wood chips for further adjustment.

4、在门框与墙之间缝隙处均塞木片，使门框较为稳定，然后往门框内灌注水泥沙浆，将水泥沙浆凝固干燥后把门缝外木片取出方可使用门的功能，但在24小时内尽量是少开启次数与力度。

4. The gap between the door frame and the wall shall be stuffed with wood chips to make the door frame more stable, and then the cement mortar shall be poured into the door frame. After the cement mortar is solidified and dried, the wood chips outside the door gap can be taken out to use the function of the door, but the opening times and strength shall be minimized within 24 hours.

本文由 山东铜门为您提供，我们的网站是： //www.doveish.com我们将以全心全意的热情为您提供服务，欢迎您的访问！

This article is provided by Shandong Tongmen. Our website is: //www.doveish.com We will serve you with wholehearted enthusiasm. Welcome to visit!